Digital Workshop

If you use the display full screen and change display mode to e.g. 800x600, the publication displays in the centre of the screen. Great!!

However if you change the resolution using the Script function ChangeDisplayMode(1) then the publication is off centre and you have to drag it into position.

The script function worked fine until I installed Service release 4.21. Just downloaded SR 4.3 and the same problem persists.


Any ideas??

Hello,

I was having similar problems with the original release of Opus Pro 04, but I think they fixed it with SR2. Although it doesn't preview correctly but when it is published I think it is OK.

I'll check and get back to you, I had to use an awkward workaroud with a recent project in August.


Joe

Hello kenkofi,

This was fixed in 04.21 (SR2) and should be working fine in 04.22 (SR3).

Have a look at the attached IMP. Also test it published and with the pub in a Window. If you have problems I suggest you email DW with your system/graphics cards specs. It would be good to let us know here too.

Just for clarity's sake; the full public version of SR3 is 04.30. 04.22 was a private test release of SR3.

Thanks for all the help. I published it, and it displays fine. However i'm sure in an earlier service release, it worked fine in preview mode.


Regards

Hi,

The preview did work in early releases but it didn't work when it was published, so for the moment I'm happy with it working in the final published file.


Also the PDF file:
Opus_04_SR3_Notes.pdf

Displays that this release is:
Service Release 3 - Version 04.22



Joe